3d earthquake models for 6th graders3/31/2024 ![]() ![]() Depending on how creative you are, you could add to this very basic model by making tiny buildings from card or little sticks to show the damage that can be done to buildings when there is an earthquake. ![]() ![]() Rub the two halves of gelatin together the cut line represents an earth fault and you will be able to see the fault build up energy and imitate an earthquake. You then need to cut the gelatin in half along the same line that you made in the plastic wrap. When you can, put it on top of the plastic wrap, covering both pieces. Warm the gelatin on the stove just until you are able to remove it from the baking pan. You then lie the two pieces down on a table so that they touch end to end. Take a piece of plastic wrap that is about the same size as the baking pan and cut it in half. You will then need to refrigerate for about six hours until it has set. Pour the boiling water into the baking pan and stir in the gelatin powder. Pour the cup of water into the pot or kettle and bring to the boil. You will need a baking pan that is about eight inches by eight inches a cup of water a pot or a kettle 12 ounces of powdered gelatin a spoon some plastic wrap some scissors and a knife. The one I’m going to show you is really simple to do. You don’t say what age group this model is for and there are many different ways to make one for an earthquake science project, including highly technical ones including computers that actually make the model have tremors. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |